Manual Gas Rearming Kit

Consists of 33gm cylinder and green indicator clip
Check before every use that the cylinder is tightly screwed in place and that the green indicator clip is in place.
To re-arm:
Remove the Co² Cylinder from the firing head by unscrewing in an anti - clockwise direction. You will notice a hole where the cylinder has been pierced. Discard the used cylinder before proceeding.

Push the lever back in position and clip the green indicator into place.

Check to ensure there is a white 'O' Ring or black washer at the bottom of the thread where Co² Cylinder screws in.

Check the new Co² Cylinder has not been used and screw into the inflator body in a clockwise direction. Ensure the cylinder is screwed fully home as tightly as possible (hand tight).